Tom’s Tips About Knowing Your Bottom
1. A clean anchor can mean that the bottom is very hard, as with tightly packed sand, which is going to be very poor holding for most anchors.
2. Loose mud of very low viscosity on your anchor may mean that the mud is too soft to hold well, but not necessarily. Often a layer of very soft mud covers a deep layer of thicker good holding mud. If thereís nowhere else to go, try to work your anchor down deeper by putting out more chain, letting the rig settle awhile before backing down, and then backing very slowly.
3. If you think youíre going to need to spend time working your anchor in, lower it in a spot where you have some dragging room to give it a chance to dig in.
4. Your rode can telegraph signals from the bottom to you. For example, rapid jerking as you drag may indicate a rocky bottom. Slow jerking may indicate good but thick mud thatís going to require a little patience to work with, and that you back down much more slowly.
to www.tomneale.com for other information
Boating and water sports involve risk. Any comments herein should be followed
at your own risk. You assume all responsibility for risk or injury to yourself
or others. Any person or entity that uses this information in any way, as a
condition of that use, agrees to waive and does waive and also hold authors
harmless from any and all claims which may arise from or be related to that
Copyright 2004-2010 Tom Neale