Viewing Blog

View All Blogs | View Blogs by Tom Neale | View Blogs in Tom & Mel Neale’s Boating Tips

<- Previous Blog by Tom Neale | Next Blog by Tom Neale ->

Tom’s Tips on Hose Clamps

By Tom Neale - Published February 02, 2012 - Viewed 713 times

1. Although hose clamps are set up for use with a straight slot screwdriver, they can also be torqued with a socket wrench.

2. Have a socket wrench, of the correct size, handy when you go to work. The screwdriver may be faster and may require less clearance, but sometimes the socket wrench will do a better job more easily.

3. Avoid over-tightening a hose clamp. There’s a tendency to do this when the connection is seeping. If the clamp isn’t tight enough, usually it takes only a little extra torque. If you tighten too much you’ll deform and maybe break the clamp and possibly damage the hose and barb.

4. If tightening a little doesn’t stop the seepage, consider that there may be something else wrong like a damaged hose end or cracked barb.
 

 


 

Go to www.tomneale.com for other information

Boating and water sports involve risk. Any comments herein should be followed at your own risk. You assume all responsibility for risk or injury to yourself or others. Any person or entity that uses this information in any way, as a condition of that use, agrees to waive and does waive and also hold authors harmless from any and all claims which may arise from or be related to that use.

 





Blog Comments

There are 0 blog comments.

Sorry there are no blog comments.

Post Blog Comments
Message:

Sorry but you must be logged in to submit comments.