• Contact Claims: 1-800-937-1937
  • Get a Free Quote: 1-800-283-2883
  • 1-800-245-2628
  • 9AM - 5PM EST
  • 1-800-365-5636
Viewing Blog

View All Blogs | View Blogs by Tom Neale | View Blogs in Tom & Mel Neale’s Boating Tips

<- Previous Blog by Tom Neale | Next Blog by Tom Neale ->

Toms Tips About Dock Cleats

By Tom Neale - Published May 12, 2011 - Viewed 1056 times

1. I’ll never forget being tied to what appeared to be a very sturdy floating dock on a very windy day, hearing a cracking noise as I sat writing an article at my computer, going up on deck, and seeing the dock plank beginning to break because of the pull on the cleat.

2. When you tie to a cleat, check, if possible to safely do so, to see that the cleat itself is secure.

3. Being bolted through a plank, even with large backup washers, often isn’t enough.

4. It’s better if the cleats are bolted through multiple stringers or hefty pilings or other more substantial structures. If bolted to pilings, be sure the cleat won’t impact your boat if the boat moves to the piling. Better built marinas can have very secure cleats.

5. The size of cleats needed depends on your boat, but don’t tie unless you’re sure that it’s adequate.

Go to www.tomneale.com for other information

Boating and water sports involve risk. Any comments herein should be followed at your own risk. You assume all responsibility for risk or injury to yourself or others. Any person or entity that uses this information in any way, as a condition of that use, agrees to waive and does waive and also hold authors harmless from any and all claims which may arise from or be related to that use.

Blog Comments

There are 0 blog comments.

Sorry there are no blog comments.

Post Blog Comments

Sorry but you must be logged in to submit comments.