• Contact Claims: 1-800-937-1937
  • Get a Free Quote: 1-800-283-2883
  • 1-800-245-2628
  • 9AM - 5PM EST
  • 1-800-365-5636
Viewing Blog

View All Blogs | View Blogs by Tom Neale | View Blogs in Tom & Mel Neale’s Boating Tips

<- Previous Blog by Tom Neale | Next Blog by Tom Neale ->

Toms Tips About Dropping Things

By Tom Neale - Published November 11, 2010 - Viewed 1142 times

1. Never drop over your outboard while it’s running. Shut it down first.

2. Whenever you pick up a wrench to work in the engine room or near the water, first look at it to see what size it is so that you can go buy another one when you drop that one.

3. If you drop a screw driver overboard, don’t entertain much hope of retrieving it with a magnet. Usually they straighten out during descent and go down pointed end first, so that the metal shaft goes straight into the mud, leaving only the plastic handle protruding from the mud. The magnet probably won’t be attracted to that.

4. Some things, when dropped into the water, don’t go straight down. They swim back and forth and may end up far from where you expect them to be. I once dove for a pair of eyeglasses which had fallen off my wife’s head. They went in with the sides open. They had found the bottom some distance from where they hit the surface, they were neatly folded, and were sitting on one end, propped up against a piling.

5. Keep a very strong magnet handy, but it’s useless unless you replace its rope regularly, especially if it goes into areas like the bilge.

Go to www.tomneale.com for other information

Boating and water sports involve risk. Any comments herein should be followed at your own risk. You assume all responsibility for risk or injury to yourself or others. Any person or entity that uses this information in any way, as a condition of that use, agrees to waive and does waive and also hold authors harmless from any and all claims which may arise from or be related to that use.

Blog Comments

There are 0 blog comments.

Sorry there are no blog comments.

Post Blog Comments

Sorry but you must be logged in to submit comments.