Viewing Blog

View All Blogs | View Blogs by Tom Neale | View Blogs in Tom & Mel Neale’s Boating Tips

Tags for Tom’s Tips About Pumps and Alarms

Pumpsandalarms  Bilgealarms  Wiredalarm  Floatswitch  Testpumps  Debris  Regularlytest  Hoses  

<- Previous Blog by Tom Neale | Next Blog by Tom Neale ->

Tom’s Tips About Pumps and Alarms

By Tom Neale - Published July 14, 2005 - Viewed 698 times

1. One of the most critical factors in dealing with water coming in is to know about it immediately. The sooner you know, the more likely you’ll be able to handle the problem.

2. Multiple bilge alarms, which sound off where you can hear them, are important. An alarm for the float switch for each pump is good. Additional independently wired alarm(s) to dedicated float switch(s) are better.

3. If there are sections of the bilge that will hold water separately from other sections, there should be not only pumps, but alarms for each.

4. Follow instructions when installing pumps and alarms. Failure to do so can make them less effective.

5. Regularly test pumps and alarms by manually activating the float switch(s), and keep them clear from debris, hoses or any other material which could impair their operation.

6. As soon you know water is coming in, stop the boat if it’s safe to do so, considering all the circumstances. With many leaks, this will slow the flow. Begin looking for the source.

Go to www.tomneale.com for other tips and information

Copyright 2004-2010 Tom Neale





Blog Comments

There are 0 blog comments.

Sorry there are no blog comments.

Post Blog Comments
Message:

Sorry but you must be logged in to submit comments.