• Contact Claims: 1-800-937-1937
  • Get a Free Quote: 1-800-283-2883
  • 1-800-245-2628
  • 9AM - 5PM EST
  • 1-800-365-5636
Viewing Blog

View All Blogs | View Blogs by Tom Neale | View Blogs in Tom & Mel Neale’s Boating Tips

Tags for Toms Tips About Pretty Engines

Prettyengines  Rawpumpimpellor  Heatexchanger  Spillage  Rustpreventionspray  Wd40  Crc  

<- Previous Blog by Tom Neale | Next Blog by Tom Neale ->

Toms Tips About Pretty Engines

By Tom Neale - Published April 17, 2008 - Viewed 1466 times

1. Often mechanics, doing a job such as changing a raw water pump impellor or cleaning a heat exchanger, will let raw (salty) water drain onto the engine. Often they can’t do the job without this spillage. The same is true with you and me. When it happens, it’s important to take remedial action.

2. Anytime you have to dump raw water onto parts of the engine, make note of where the water touches the engine and, after the job, spray it with fresh water. Start the engine and let it get warm enough to dry the moisture. Then spray with a good appropriate corrosion inhibitor after the engine cools.

3. You can often avoid raw water spillage on the engine by carefully fashioning a shield/funnel with heavy grade aluminum foil. This causes the spilling water to run down to the bilge on the foil rather than via the engine.

4. Buy a can of manufacturer’s paint (or the equivalent) for your engine and keep it handy. In all seriousness, it’ll help keep the engine looking great and this will help resale value if that’s in the future.

5. Never keep that paint in the engine room or any other heated space or place where it could be near a source or cause of ignition.

6. Also keep nearby (but not near causes of ignition) rust prevention spray, such as WD 40, CRC or Starbright Corrosion Protection Spray Lube. If you have to go hunt these down when you see rust forming, you’ll be less likely to use them.

7. Whenever you spray material such as the products mentioned here, remember that they are probably highly combustible or even explosive. Read and carefully follow all instructions and warnings on the cans.

8. Take great care to not breathe harmful fumes.

Go to www.tomneale.com for other information

Boating and water sports involve risk. Any comments herein should be followed at your own risk. You assume all responsibility for risk or injury to yourself or others. Any person or entity that uses this information in any way, as a condition of that use, agrees to waive and does waive and also hold authors harmless from any and all claims which may arise from or be related to that use.




Copyright 2004-2010 Tom Neale

Blog Comments

There are 0 blog comments.

Sorry there are no blog comments.

Post Blog Comments

Sorry but you must be logged in to submit comments.